The Red Devil 3D
is a large sized - 500 class brushless powered 3D Aerobatic RC Airplane. Features large wheels that are BIG enough to take off tall grass and rough surfaces at the flying field.
Has enough power to HOVER
at 1/2 throttle! Will perform any aerobatic maneuver with ease!
Features a 500 class brushless motor swinging a 12x6 propeller , 4 Channel 2.4 GHZ radio System, and a steerable tail wheel. Made from a durable EPO foam that is both rigid and lightweight.
LED lights are factory installed inside each wingtip that adds to the overall appearance.
A balancing auto peak lipoly A/C CHARGER is included! Long 20 Minute Run Times!
the included 2400 mah 11.1 volt - 20c rated Lipoly battery ,the RED DEVIL can easily get 20-22 minutes of flight between charges!
That's much LONGER than most RC Nitro powered airplanes!
Advanced Brushless Motor Technology
This is due to the increased efficiency of the included brushless motor. Brushless motors
have no internal brushes (friction and heat + energy loss and wear)
that also means its performance will never degrade over the lifetime of
your motor. Same power and torque no matter how many times you use it
Extra Large Landing Gear
Comes with an extra large landing gear that can take off and land in "tall grass fields" with ease.
Large 55 inch wingspan
Large 55 inch wingspan makes it easy to see, fly and handle more
realistic . A larger plane is also less prone getting knocked around in
Features large wheels that allow for take-offs in tall
and landings in tall grass. Front nose wheel is servo controlled to
allow for sharper turns needed for taxiing on the ground.
EPO FOAM = 10x stronger than regular styrofoam and half the weight of EPP foam.
The RED DEVIL 3D is made from very durable EPO Foam. In fact its about ten times stronger than regular styrofoam.
Easy To Fly - The Ultimate RC Airplane Trainer
Wing Tiger V2 is super east to learn how to fly on. Its large main wing
has enough wing area to easily dead stick in on landings without
stalling. It also allows the WTV2 to be flown at very low speeds of
10-15 mph. This allows novice to get accustom dot the flight controls.
Once mastered you can reach top speed of 60 miles per hours!
Aerobatic - Fun to Fly
The RED DEVIL 3D is highly aerobatic, and can easily hover , harrier, inverted flight,
rolls, loops, knife edge, stall turns.
In Flight Videos and Video Setup Guides are shown below.
Weight (Without battery): 1135g/40 oz
Flying Weight (with battery): 1350g/47.6 oz
Horizonal Static thrust: 1300g/45.9 ozConfiguration:
Radio System: 2.4GHz - 4 Channel Radio
Motor: Brushless Motor - ST3511-KV850
ESC: 40 Amp Brushless
Battery: 2400mAh , 11.1 volt with balancing plug
Charger: Balanced auto peak cut off with variable charge rate.
Red Devil Video Setup Guide from Parkflyers RC on Vimeo.