Dig Kit (KC10) Dig conversion kit for KC10 chassis  [KY-CLW002]

DIG kit for KC10

The Kyosho CLW002 Dig Kit is an RC-scale transmission accessory designed to enable the DIG function on KC10 chassis models by using an available third channel from the transmitter. When engaged, the DIG function locks the rear drive while retaining drive to the front wheels, allowing a much tighter turning pivot than the chassis' standard minimum turning radius.

This kit converts the transmission's built-in DIG mechanism to be switched on and off remotely, so operation and tuning are handled from the transmitter rather than by manual switches at the car. Typical use is to assign the DIG activation to an auxiliary channel or a three-position switch so the driver can enable the lock only when needed, for example on hairpin turns or tight obstacles during track runs or technical course sections.

Installation overview: the kit interfaces with the transmission's DIG actuator and the radio system; it requires an unused transmitter channel and basic wiring to the vehicle's receiver or an onboard switch harness. Because compatibility and wiring implementations vary by setup, follow the chassis' service manual and confirm whether the KC10 transmission in your model already includes a DIG mechanism before installation.

In practice the CLW002 Dig Kit is used to add on-demand rear-drive locking to KC10 builds, letting drivers tighten line choice and reduce corrective steering through tight corners.